Opening Instructions
Powerbug

Opening Instructions

  1. Remove card board container from pallet. Being properly trained in the use of a box cutter cut away the box at the base of the pallet and lift box over The PowerBug and remove.

  2. It is preferred to attach the handle at this time. See the website for a video illustrating how to do this. Raise the handle into proper position

  3. With a team lift, gently lift the head of The PowerBug head up by pulling down on the handles. And gently roll the PowerBug off the pallet from the rear.

  4. Remove the grease gun from it’s box and follow label instruction contained in the box and install the grease cartridge into the grease gun. Pump several times to prime the grease gun until grease comes out.

  5. Lubricate the head assembly with 5 pumps of grease.

  6. Plug the charger into an outlet in a safe combustible free area and charge The PowerBug before initial use.
Share by: